ISP TECHNOLOGIES

ISP Technologies

IMPRESSION PEDAL

The ISP Technologies Impression™ Pedal is a high quality DSP based stereo multi-effects pro-cessor with Chorus, Delay, Reverb and Flange. Use up to 3 effects simultaneously including chorus or flange plus delay and reverb.

The Impression also includes a TAP button allowing easy adjustment of delay time and chorus or flange modulation time by measuring the time interval between two taps. Designed to be a perfect match with the THETA pre-amp pedal, the Impres-sion will deliver a full complement of the most commonly used effects.

Buy Online

 

DescriptionThe impression pedal offers ease of use with a direct level and effects mix level. The Impression pedal can be used in a series or parallel effects loop of an amplifier or inserted in line after a guitar preamplifier or distortion pedal. The chorus / flange button will switch on and off the selected effect; holding down the chorus / flange button will change the effect from chorus to flange or flange back to chorus. Two consecutive taps on the TAP button will set the modulation rate for the chorus or flange. The delay button will turn on and off the delay effect. Holding the delay button down will change the amount of regeneration from a single delay to an increasing amount of regeneration. Two consecutive taps on the TAP button will set the delay time. The reverb button will turn the reverb effect on and off. Holding the reverb button down will change the mix of the reverb rela-tive to the level of the other effects, there are six different preset levels. This will allow the user to select the desired amount of reverb in the mix. The Impression pedal uses an external 9VAC power adaptor with an internal voltage multiplier providing professional headroom with a +/- 15 volt power supply. The Impression incorporates a mono input and left / right stereo outputs. Add the Impression pedal to your rig and enjoy the quality effects you have been searching for.

Features The Impression pedal uses an external 9VAC power adaptor with an internal voltage multiplier providing professional headroom with a +/- 15 volt power supply and incorporates a mono input and left / right stereo outputs. Add the Impression pedal to your rig and enjoy the quality effects you have been searching for.

Impression Pedal Manual

Specs
Input Impedance – 560k ohms
Maximum Input Level – +11dbu
Maximum Output Level – +11dbu
Dynamic Range – 93db A weighted
Decimator Effective Noise Reduction – 12db
Noise Floor / Mix Level at 1/2 – -90dbu
CHORUS Modulation Time – User Set up to 5 seconds
FLANGE Modulation Time – User Set up to 5 seconds
Maximum DELAY Time – 800 milliseconds
Reverb Mix – User Set from Odb to -21db
Dimensions – 7.4”L x 4.7”W x 1.42”H
Weight – 1.06 lbs
Power – 9VAC External Adaptor
Power Consumption – 200 milliamps at 9VAC

Share this with a friend...Share on FacebookTweet about this on TwitterPin on PinterestEmail this to someone